Cobra Colour Control 12 Manual do Utilizador descarregar pdf (Página 11)

Delete a Step or Steps

1.Enter the edit mode

2.Tap the step button to scroll to the step you wish to delete.

3.Tap the delete/rev button when you reach the step you wish to delete. All the LED's will light,

indicating the deletion of the step.

4.Repeat steps 2&3 until all of the unwanted steps have been deleted.

5.Press and hold the record and rec exit button. The scene button LED will turn supress, indicating

that the edit mode has been exited.

Insert Step or Steps

1.Enter edit enable.

2.Using the step button, go to the position you wish to edit within a scene.

3.Using the mode select button put the unit into 1-48 mode.

4.Record a step.

5.Put the unit back to chase<>scene mode.

6.Press the insert button (your step has been added). You can check your scene has been added

by using the step button to go through the individual steps.

7.Exit edit mode.

Modify a Step or Steps

1.Enter the edit mode.

2.Tap the step button to scroll to the step which you wish to edit.

3.Whilst holding the up or down button, tap the flash button corresponding to the DMX channel of

the scene you wish to modify. Do this until you reach the desired intensity value read from the

display. You may then tap the flash button until you are satisfied with the new scene.

4.Repeat steps 2, 3 and 4 until all the steps have been modified.

5.Exit edit mode.

Notes:

Part of entering the edit mode is selecting which scene you wish to edit. See section on edit enable

for further instructions.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Sem comentários

Cobra Colour Control 12 Manual do Utilizador Página 11