Cobra Colour Control 12 Manual do Utilizador Página 12

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 19
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 11
12
Erase a Scene/Chase
1.Record enable.
2.Select the page the desired scene/chase is on.
3.Press and hold record button.
4.Tap the flash button which corresponds to the scene/chase you wish to delete twice.
Erase all Scene/Chases
1.Record enable.
2.Hold record button and press flash 1,4,2,3 in sequence.
3.Release the record button, all LED's will flash indicating all programmes (scenes and chases)
have been deleted.
Record Clear
1.Record enable.
2.Record a scene with one or more steps.
3.If you are not satisfied with the scene, you may press and hold the record button and tap the rec
clear button. All LED's will flash, indicating the scenes have been cleared.
Notes:
All the scenes stored within the temporary memory of the controller will be erased by this process.
This will not affect the scenes already programmed onto a scene fader.
Faders 25-48 are used for the playing back of scenes/chases already recorded. This is only when
the recorder is in the chase <> scene mode. In this instance, Master Fader A will control the manual
fader controls, while the Master B will control the scenes being played back.
Playing a Scene/Chase
1.Press the mode select button to select chase <> scene mode.
2.Press the page button to select the correct page where the scene you wish to run is located.
3.Push the Master Fader B into its maximum position (fully down).
4.Move the desired channel fader (25-48) to its maximum, and the scene will fade in depending
upon current fade time.
5.Move the channel fader to adjust the output of the current program.
Notes:
The current mode is indicated by the 3 LED's:
Red is the Chase <> Scene mode
Yellow is 2-scene pre-set A/B mode
Green is 1-48 single mode
You may press and hold down the relevant flash button for the scene/chase to trigger momentarily
whilst working in scene/chase mode.
Vista de página 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

Comentários a estes Manuais

Sem comentários