Cobra Colour Control 12 Manual do Utilizador descarregar pdf (Página 5)

Controller Rear:

20. DMX Polarity Switch.

21. DMX OUT

22. DC power

23. ON/OFF

First Time Operation:

1. Remove all packaging materials.

2. Connect a DMX cable from the controller to the first light, then from the first light to the second. Do

this until all four lights are connected to the controller.

3. Plug the controller in to the mains using the supplied AC/DC power supply then plug your four LED lights

in to the mains.

4. Set the first light to DMX address 1, set the second to DMX address 9, the third to DMX address 17 and

the forth to DMX address 25. (Some LED lights will have a digital display and some will have small dip

switches).

5. Check Blackout light is not lit. If it is, press the Blackout button.

6. Press fixture buttons 1-4. The corresponding blue LEDs will light up.

7. Move red, green, blue and master sliders up – your LED cans should light up. If they do not, try switching

the polarity switch on the rear of the controller.

8. Follow the rest of the manual for all your programming options.

Enter Programme Mode:

1. Press and hold the Record button for 5 seconds.

Exit Programme Mode:

1. Press and hold the Record button for 5 seconds.

Record a Scene:

1. Press and hold the Record button for 5 seconds to enter the Programme Mode. (The red Record light

will light up).

2. Select the fixture you want to programme by pressing the desired Fixture button.

3. Set the faders to the desired values.

4. Decide what page of scenes you are going to save on. You can select Page 1 or 2.

5. Press the Record button then press the desired Scene button you want to record.

6. Press and hold the Record button for 5 seconds to exit Programme Mode.

**Any existing scenes will be overwritten**

20 21 22 23

1 2 3 4 5 6 7 8

Sem comentários

Cobra Colour Control 12 Manual do Utilizador Página 5