Cobra Colour Control 12 Manual do Utilizador descarregar pdf (Página 8)

Fixture 1 Fixture 2 Fixture 3 Fixture 4

Red: CH1 Red CH9 Red CH17 Red CH25

Green CH2 Green CH10 Green CH18 Green CH26

Blue CH3 Blue CH11 Blue CH19 Blue CH27

Master CH4 MasterCH12 MasterCH20 MasterCH28

Unpatch Channels:

1. Press and hold the Patch button for 3 seconds.

2. Select the fixture by pressing the Fixture button

3. Press and hold the TAP/SYNC button. Now press the corresponding scene button that you want to

unpatch. Scene buttons 1-8 are DMX channels 1-8.

4. All LEDs will flash to show your operation was successful.

5. Press the Patch button for 3 seconds to exit.

Maintenance:

The COBRA Colour Controller 4 requires almost no maintenance. However, you should keep the unit clean.

Disconnect the mains power supply then wipe the cover with a dry cloth. Do not immerse in liquid. Do not

use alcohol or solvents.

Keep connections clean. Disconnect electric power then wipe the DMX and audio connections with a dry

cloth.

Troubleshooting:

COBRA Colour Controller 4

This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps

below in sequence until a solution is found.

1. Fixture does not respond to controller: Check the DMX address of the fixture and the controller. Make

sure they match. Make sure the connections are correct.

2. Interference between chases: If the same channel is assigned to different running chases, the one with

the highest channel value will take precedence.

3. If the device does not operate properly disconnect the mains power.

4. Check all power connections and other cables.

5. If all of the above appears to be okay plug the unit in again.

6. If nothing happens after 30 seconds unplug the device.

7. If none of the above appear to work consult your dealer.

1 2 3 4 5 6 7 8

Sem comentários

Cobra Colour Control 12 Manual do Utilizador Página 8