Cobra GPS 500 Guia do Utilizador descarregar pdf (Página 77)

www.gpssource.com

+1 719-561-3680

The WarFighter Source for GPS Retransmission Systems Page 77 of 102

Document Class/Number:

DOC-UMN-AAA-AD

GLI-COBRA USERS MANUAL Revision: 001F

7.0 ECHO II System Operation:

SC GPS

OUTPUT

POWER

OUTPUT LEVEL

ADJUSTMENT

SIGNAL

CONDITIONER

Power

Connector

SC GPS

OUTPUT

BRIGHTNESS

ADJUST

SC GPS INPUT

SC POWER

BUTTON

SC DISPLAY

RS232 PORT

XMIT & FAULT

INDICATOR

LIGHTS

Complete installation of the ECHO II Signal Conditioner according to the installation instructions in the

previous sections prior to operation of the ECHO II.

1. Enable ECHO II Power: To enable the ECHO II Signal Conditioner, press and hold the power button

on the face of the ECHO II for 2 seconds until the display turns on. Once the power is on, the system

will begin transmitting the GPS signals within 10 seconds if the system is fully operational. Although

the System will begin transmitting the within 10 seconds, the system may require as much as 4 minutes

to become fully initialized.

2. Disable ECHO II Power: To disable the ECHO II hold the Power button for 3 or more seconds.

3. DISPLAY: The DISPLAY indicates the power level/brightness level of the ECHO II. The DISPLAY will

also indicate any faults detected by the ECHO II and the fault code.

4. XMIT LED: The XMIT LED indicates the transmit status of the ECHO II. If XMIT is illuminated or

flashing, the ECHO II is transmitting the GPS signals through all operational GPS Retransmission

Antennas. If XMIT is flashing, the ECHO II is acquiring satellites.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 101 102

Sem comentários

Cobra GPS 500 Guia do Utilizador Página 77